
Deck Sanding
Sanding removes the greying, old coatings and rough, raised grain left by years of weather. Nails are punched below the surface first, so the sander cuts the boards flat without catching.

Renew a grey, splintery deck and get back an outdoor space you'll actually want to use.
The Gold Coast sun breaks down the surface of exposed timber and rain washes the loose fibres away, which is what turns a deck silver-grey and rough underfoot. Sanding takes that weathered layer off and gets back to clean timber that will take a fresh coat.
With new decking oil soaked into the boards, the deck has its colour back and is protected through the next wet season, ready for barbecues and long evenings outside.
What you can expect when we restore your deck:
If your deck has seen better days, a sand and oil can often bring it back for far less than new decking.
Call (07) 5651 0891 or use the form for a free quote.

Sanding removes the greying, old coatings and rough, raised grain left by years of weather. Nails are punched below the surface first, so the sander cuts the boards flat without catching.

Unlike the hard film used in timber floor polishing indoors, decking oil soaks into the timber to slow down moisture and sun damage. A tinted oil can bring back the colour of the original boards, and it's easy to recoat later because there's no film to peel or flake.

Split, cupped or soft boards are replaced before sanding, the same way we handle timber floor repairs indoors, so the new timber is sanded and oiled with the rest of the deck. Loose boards are re-fixed, and nails that keep lifting are swapped for decking screws.

Once the coating has gone, the timber soaks up rain and dries out again in the sun, over and over. That cycle opens up cracks along the grain and lifts the ends of the boards. Boards that have split too far can't be sanded back, only replaced.

Why Choose Us?
The good news is that grey timber is a surface problem long before it becomes a structural one. Most weathered decks still have plenty of sound timber under the top layer, and catching them at this stage means a sand and oil rather than new boards.
We check every board before we start, replace the few that are past saving and sand the rest back to clean timber, so the oil soaks deep into the grain. You end up with a deck that looks cared for again and is protected through the seasons ahead.
Here's what we bring to every deck:
Deck work depends on dry weather, so we keep you posted on the booking and move it quickly if rain comes through.
The deck is sanded, cleaned and left to dry before any oil goes on, so it soaks into the timber evenly instead of sitting on top.
A sand and oil costs far less than new decking, and your quote shows exactly what's included.
For a Gold Coast floor sanding team that can restore your deck to one you'll want to spend time on again, get in touch. Call (07) 5651 0891 for a free quote.
A smooth, freshly oiled deck is comfortable underfoot again, without splinters or rough patches, so it's ready for entertaining and long weekends outside.
Oil slows down how much water the timber takes in, which means less cracking, splitting and cupping as the seasons change.
A deck back to its natural colour lifts the look of the whole backyard, which counts when you're entertaining, selling or renting the house out.
Sanding and oiling costs a fraction of new decking, and sound boards can be restored many times over their life.

Get in touch with the size of the deck and a few photos if you have them, and we'll arrange a visit. We check the boards, fixings and any old coating, then quote for sanding and oiling.
Damaged boards are replaced and nails punched down, then the deck is sanded back to clean timber. Edges and steps are sanded by hand where the machine can't reach.
Once the timber is clean and dry, decking oil goes on in thin coats that soak into the boards. The number of coats depends on the timber and how weathered it was.
We let you know when the deck can take foot traffic and furniture again, and how often to recoat it. A clean and a fresh coat every so often keeps the boards from going grey again.
Most decking oil makers recommend checking the deck every year, and a deck in full sun or around a pool usually needs a fresh coat about that often, while a covered veranda can go longer. The signs it's due are water soaking in instead of beading on the surface, and the timber starting to fade or grey.
Recoating before the timber goes grey means a clean and a coat of oil rather than a full sand, which keeps the cost down each time.
If you're not sure where your deck is at, send a few photos and call us on (07) 5651 0891 and we'll tell you what it needs.
Not always. If the old oil has faded but the timber is still smooth and its natural colour, a thorough clean and a fresh coat may be enough. A deck that has gone grey, feels rough or has a coating that's peeling needs sanding, because new oil can't soak into weathered fibres or stick to a failing film.
Sanding also removes the raised grain and splinters that make an old deck uncomfortable to walk on barefoot.
To find out which your deck needs, get in touch and we'll take a look.
Yes. Paint and film-forming coatings like varnish have to come off completely before oil goes on, because oil can't soak through them and new coats won't hold on a coating that's already peeling. Sanding removes the old coating along with the weathered timber underneath.
Thick paint takes longer to sand off than a faded oil, especially between boards and around the edges, so it's worth mentioning when you ask for a quote. Call us on (07) 5651 0891 and we'll factor it in.
Any time with a run of dry weather works. The deck needs to be dry before sanding and stay dry while the oil soaks in, and oil shouldn't go on in the hottest part of the day, because it dries on the surface before it can penetrate.
On the Gold Coast, the wet months over summer make bookings harder to plan, so spring and autumn are the most reliable times. Booking before summer also means the deck is ready when you'll use it most.
If the frame underneath is sound and most of the boards are solid, sanding is almost always worth it. Replacing a few split or soft boards and sanding the rest costs far less than new decking and gives you a deck that looks close to new.
Replacement makes more sense when the joists or bearers have rotted, or when so many boards are damaged that you'd be replacing most of the surface anyway. We check the frame and boards when we quote, so you can make that call with the full picture.
If you're weighing it up, call us on (07) 5651 0891 and we'll give you a straight answer after an inspection.
We service the Gold Coast and Scenic Rim including these townships. Not sure if we cover you? Give us a call.

Servicing the Gold Coast & Scenic Rim